1.To Place the nipples, first use compressed air to clean the hole, then carefully screwed the nipples into it (do not damage the thread).
2.To connect the electrodes, when there's 20-30mm distance between the two electrodes, using compressed air to clean the two extremes.
3.Connector locations should be selected c-map.
4.When use the wrenches to connect electrodes, should be fully tighten to specified torque.
5.To avoid electrode broken, please remove the insulating material in the furnace.
6.To avoid electrode broken, pls. place the big block in the lower and smaller block at the upper.